Critical Services

Hospital, R&D facilities and data centers all require reliable power backup capabilities. RE³ offers 24/7 reliable generator response by keeping their oil clean, dry and ready to perform!

Available Units

Conserver® H2

(RECOMMENDED FOR TRUCKS FROM CLASS SA TO CLASS SA, MASS TRANSIT, CONSTRUCTION VEHICLES, AND MARINE ENGINES ALL WITH RESEVOIRS UNDER 20 GALLONS)


The H2 is the larger of the commercial units designed for purification of engine lubricating fluids. This unit can purify fluid in equipment that uses between five and twenty gallons. The H2 system is designed for direct attachment on class 8 trucks, on and off road construction equipment, marine equipment and mass transit vehicles. The system uses the pressure of the engine oil system to move the oil from the engine through the Conserver® unit and then gravity feed the purified oil back to the engine’s reservoir. The unit will filter out damaging particles and remove water, allowing the equipment to operate more efficiently. This will extend the life efficiency of the engine oil as well as the engine itself. Next Generation will provide the Conserver® H2 and the installation kit for installation to the frame.  A mounting bracket is available as an additional option to purchase.

Specifications

Flow Rate: 13.5 Gallons per Hour   

Unit Capacity: .8 Gallons   

Tank Capacity: N/A   

Dimensions: 18.5" High x 4.5" Wide  x 5.75" Deep  

 Weight: 20 lbs   


Conserver® HI4 Unit

(RECOMMENDED FOR GEAR BOXES, PUMPS, COMPRESSORS, GENERATORS, RESERVOIRS, AND MARINE EQUIPMENT WITH RESEVOIRS UNDER 100 GALLONS.)


This model uses a single HI4 unit for purification of fluid power systems using up to a 100 gallon reservoir. When the environment allows for a unit to be directly attached to the equipment near the fluid reservoir the Model HI4 is the best solution. The Conserver® system uses the pressure of the equipment’s fluid system to move the fluids from the reservoir to the Conserver® unit and uses gravity to flow the fluid back to the equipment reservoir. Non pressurized system will require the use of an optional pump to supply the fluid to the Conserver®. With pressure between 5 and 15 psi, a sufficient flow will occur to the Conserver®. The System Control Box supplies the necessary logic and controls to assure that the Conserver® unit performs properly. Multiple micron retention filtration options are available to assist you in achieving your targeted ISO cleanliness code. Moisture level target is to maintain levels below 250 PPM. The customer will provide the mounting bracket, (template included) for installation. Hoses, Pumps and other optional items are available.

Specifications

Flow Rate: 60.5 Gallons per Hour   

Unit Capacity: 3.2 Gallons   

Tank Capacity: N/A   

Dimensions: 36.0" High x 8.0" Wide x 9.5" Deep 

Power: 120 - 240 VAC   

Weight: 78 lbs.